;{CR10X}
;
*Table 1 Program
  01: 60        Execution Interval (seconds)

;OBS-12 instruction
1:  SDI-12 Recorder (P105)
 1: 0        SDI-12 Address ;              OBS-12 address
 2: 2        Start Measurement (aM2!) ; wipe, then measure
 3: 2        Port ;               <====== connected to C2
 4: 1        Loc [ mean      ] ;      mean of 100 readings
 5: 1.0      Mult
 6: 0.0      Offset

;If time is at the begining of a interval, then do
2:  If time is (P92)
 1: 0        Minutes (Seconds --) into a
 2: 1        Interval (same units as above)
 3: 30       Then Do

3:  Do (P86)
 1: 10       Set Output Flag High (Flag 0)

;Site specific identifier (1 - 511)
4:  Set Active Storage Area (P80)
 1: 01       Final Storage Area 1
 2: 510      Array ID

;Writes out time from datalogger clock
5:  Real Time (P77)
 1: 1120     (Same as 1220) Y,D,Hr/Mn

;Write out 6 input locations starting at mean
6:  Sample (P70)
 1: 6        Reps
 2: 1        Loc [ mean      ]

7:  End (P95)


*Table 2 Program
  02: 0.0000    Execution Interval (seconds)

*Table 3 Subroutines

End Program

-Input Locations-
1 mean      1 1 1
2 variance  1 1 0
3 median    1 1 0
4 BES       1 1 0
5 min       1 1 0
6 max       1 1 0
7 _________ 1 0 0
8 _________ 1 0 0
9 _________ 0 0 0
10 _________ 0 0 0
11 _________ 0 0 0
12 _________ 0 0 0
13 _________ 0 0 0
14 _________ 0 0 0
15 _________ 0 0 0
16 _________ 0 0 0
17 _________ 0 0 0
18 _________ 0 0 0
19 _________ 0 0 0
20 _________ 0 0 0
21 _________ 0 0 0
22 _________ 0 0 0
23 _________ 0 0 0
24 _________ 0 0 0
25 _________ 0 0 0
26 _________ 0 0 0
27 _________ 0 0 0
28 _________ 0 0 0
-Program Security-
0000
0000
0000
-Mode 4-
-Final Storage Area 2-
0
-CR10X ID-
0
-CR10X Power Up-
2